The surface of the composite floor is covered with a layer of solid wood, which has the visual effect of solid wood, but it does not need to be taken care of like a solid wood floor. It is more convenient to laminate the floor. Although the texture is not comparable to the solid wood floor, some simulation effects are good. Also good, the key, the laminate flooring is particularly leather, there is no need to maintain, and some good laminate flooring is as wear-resistant as tiles. What problems should be paid attention to during the renovation of the laminate flooring.
1. Base level decoration standard
The base layer of the composite floor is required to be flat, dry and clean.
2, waterproof work can not be less
Before laying the floor board, the floor or bungalow of the building shall be waterproofed.
3, cushion construction requirements
The cushioning material can be used with a 3mm thick foam pad with a plastic film or a 10-12mm thick padding, butt joint and plastic interface; high-quality multi-layer plywood with a thickness of 9-18mm can also be used. Each multi-layer glue should be divided into small pieces, the area should be less than 0.7m2, it is best to use paint to prevent corrosion, fixed on the ground, the nails must be firmly fixed around the board, and the gap between the board and the board should be 3-6mm, and the tape should be sealed.
4, the floor pavement trend
The direction of the pavement floor is usually the same as the direction of the room. The grooves are paved to the wall from left to right or from right to left. The wooden wedge is placed between the floor and the wall, leaving the expansion joint. In dry areas, the floor is wet, and the expansion joints should be kept small; the expansion joints in wet areas should be kept large.
5, the final row of the floor finishing standards
The last row of floors is cut, assembled, and tightly tied with a hook or a spiral top.
6, closing the bridge installation
In the interface between the room, the hall and the hall, the floor must be isolated, leaving enough to stretch the seam, and connect with the closing bar and the hardware bridge.
7, the skirting board installation
The thickness of the optional skirting board should be greater than 1.2cm. During the installation, the floor expansion joint gap is within 5-12mm, and the polystyrene board or elastomer is used to fill in the gap to prevent the floor from loosening. Install the skirting board and be sure to cover the stretch seam.
Concerned about surprises
Label: Composite floor construction standards and precautions
Previous: Paint sales are not tracked, everything is empty! Next: What is the reason for the small pit on the wall of the paint?
Kitchen Cooking Utensils,Unique Kitchen Gadgets,Kitchen Utensils And Gadgets,Fun Kitchen Gadgets
Garwin Enterprise Co.,Ltd , https://www.garwincn.com