Sliding line maintenance:
Wuhan Tianli Electric believes that the safety wire contact line should be inspected regularly during normal operation, because the power equipment is the main production tool for each industrial and mining enterprise. A slight error will affect the production efficiency of the factory. When checking the trolley wire, check whether every 6m of the connector is loose and disengaged. When checking the conductive device, check whether the rotating part is flexible, whether the tension spring is fatigued, the brush is worn, etc. (These conditions will affect Slide-line conductive type can follow the conductivity of the conductive device and should be adjusted in time.
During the renovation of holiday equipment, conductors are disconnected from the conduits to check the wear of the conductive telephone rollers. If the brush extension is less than the specified effective length, it must be replaced in time. If the guide roller is deformed seriously, it must be replaced to keep the conductor running. The normal contact with the brush is good and check the cause. The brush is the only part that wears out during normal use.
installation method:
1, first press the Z-bracket on the traffic pressure plate with a spacing of 1.2 meters;
2, then the entire copper wire with a small iron hook into the slip tube, and then connect the two connected joints, (connecting the pressure plate) and then put the small iron hanger into the upper groove of the tube, 1.2 meters away . Hanger directly on the Z-bracket, the entire line pulled up at once;
3. Is the current collector installed at the lower end of the slide wire and welded on one end of the tube head;
4. The copper wire end of the slide wire used directly by the power supply.
Wuhan Tianli Electric believes that the safety wire contact line should be inspected regularly during normal operation, because the power equipment is the main production tool for each industrial and mining enterprise. A slight error will affect the production efficiency of the factory. When checking the trolley wire, check whether every 6m of the connector is loose and disengaged. When checking the conductive device, check whether the rotating part is flexible, whether the tension spring is fatigued, the brush is worn, etc. (These conditions will affect Slide-line conductive type can follow the conductivity of the conductive device and should be adjusted in time.
During the renovation of holiday equipment, conductors are disconnected from the conduits to check the wear of the conductive telephone rollers. If the brush extension is less than the specified effective length, it must be replaced in time. If the guide roller is deformed seriously, it must be replaced to keep the conductor running. The normal contact with the brush is good and check the cause. The brush is the only part that wears out during normal use.
installation method:
1, first press the Z-bracket on the traffic pressure plate with a spacing of 1.2 meters;
2, then the entire copper wire with a small iron hook into the slip tube, and then connect the two connected joints, (connecting the pressure plate) and then put the small iron hanger into the upper groove of the tube, 1.2 meters away . Hanger directly on the Z-bracket, the entire line pulled up at once;
3. Is the current collector installed at the lower end of the slide wire and welded on one end of the tube head;
4. The copper wire end of the slide wire used directly by the power supply.
The liquid inlet/outlet adopts a ceramic hard seal structure, the liquid is in contact with the ceramic throughout the entire process, and does not touch the stainless steel jacket. The ceramic parts of the liquid inlet/outlet can be disassembled for cleaning and disinfection like the ceramic plunger rod and the ceramic reversing rod, which completely solves the problem of cleaning the dead angle between the steel jacket and the ceramic.
Ceramic plunger pump,Micro ceramic plunger pump,Plunger pump
Changzhou Yuanwang Fluid Technology Co., Ltd. , https://www.ywfluid.com