The arrival of intelligent products has undoubtedly brought convenience to our lives. The sanitary ware has been intelligently upgraded, and our installation methods have to be changed accordingly. Today, Xiaobian is a detailed introduction to the smart toilet installation steps. If you want to be comfortable and go to the toilet, you need to be cautious when installing step by step!
1. Before installation, check whether the sewage pipe is unblocked and the installation floor is clean.
2. Install the matching sealing ring on the drain outlet of the toilet.
3. Determine the toilet installation location. Lay the toilet drain to the pipe drain and slowly lower it, adjust the correct position, then use chalk or whiteboard pen to mark the line around the toilet and determine the mounting hole.
4. Hit the mounting hole. Align the foot and the wire to mark the hole, and use the impact drill to make the mounting hole. The diameter is 10mm, the depth is 60mm, and the expansion rubber nail is loaded. Generally, the ground wire is not required to be installed.
5. Apply glass glue to the inside of the marking line.
6. Align the mounting holes with the surrounding glass glue on the toilet and slowly press down until it is level.
7. Put the glass glue on the joint between the toilet and the ground, and trim the circumference to ensure the appearance.
8. Install the ground wire.
9. Connect the inlet pipe and check if the filter is installed.
10. Clean the floor and tools and prohibit immediate use. Because glass glue curing generally takes 24 hours, it is necessary to keep the water around the toilet for 24 hours.
ZHITONG PIPE VALVE TECHNOLOGY CO.,LTD , https://www.ztpipevalve.com