First, the tile is not serious 1. The material is too dry: Do not allow the material to fill the mold cavity under pressure and proper humidity adjustment is required.
2. Less feeding: If the cylinder is fed, it may be stuck on the wall of the cylinder. Need to clear the wall.
3. Under the bias: cause more material on one side, less material on one side. Adjust the material feeder.
4. The ratio is wrong: the proportion of sand in the raw material is so large that the tile cannot be compacted.
5. The filter cloth is too tight: When replacing the filter cloth, remember to tie it with the lower mold and loosen it properly.
6. Oil pressure is not enough: check whether the pressure of the main press reaches 8 ~ 15Mpa.
two. There are cracks in the tile. No release agent was used.
2. The release agent sprayed too little. The injection pressure can be adjusted up slightly.
3. The center of the wator plate is biased.
4. Wafer plate and tile gap is too large, generally should be 1 ~ 5mm. Too large a gap will cause the tile to break, and the gap will be a bad roof. Small, 5. The Valto Board is lifting too fast or shaking. Adjust the corresponding gas flow valve.
6. Too much sand was added to the ingredients, causing the tiles to have insufficient tackiness, and the tiles were cracked when they fell.
three. Tiles partially softened. The filter layout part is stuck and the bottom hole of the lower mold is blocked and cleaned.
1. The system has no pressure and the oil pump is reversed: the wiring is wrong and the steering is adjusted.
2. Insufficient power: The motor is faulty or has a low voltage, detects the power supply or repairs the motor.
3. Pump temperature too high: oil viscosity is too low, pump damage, insufficient cooling, or interruption. Replace or repair the oil pump to improve the cooling system. Use a good viscosity hydraulic oil.
4. Pump speed is too low: Coupling or motor is faulty. Exclude 5. Incorrect adjustment or component damage: incorrect pressure adjustment, damaged relief valve, oil leakage from the cylinder seal, adjustment to correct pressure, replacement of the relief valve, replacement of seals or cylinders.
The above is a colorful tile machine. The troubles in the tile manufacturing system and the processing methods in the tile production equipment hope to bring you some help. Jiangsu Tianpeng tile equipment telephone
Stainess Steel Hose/Tube,Stainless Steel Hose Tube,Stainless Steel Tube Radiator Hose,Stainless Steel Pipe To Tube Adapter
NINGBO RIDE SPORT EQUIPMENTS CO.,LTD. , https://www.assur-valve.com