Wire-cutting machine Tools are not suitable for working in dirty and high-temperature and humid environments. The power supply environment of the power grid also has high requirements. The power supply voltage of the machine tool should not be inferior to ±10%, and the three balances are stable. A grid source must be installed with a regulated source for a grid that is too harsh. In addition to the normal maintenance and lubrication, the wire-cutting machine tool must also carefully maintain the following parts:
The guide rails and lead screws of the wire cutting machine tool machine must not be contaminated with dirty water and dirt. Once it is stained with dirt, wipe it with clean cotton yarn and then wipe it with cotton wool dipped in 10# oil.
The wire guide machine guide wheel and bearing, for the life of the guide wheel and bearing, should also replace the too dirty coolant, such as not open the machine for a short time, let the guide wheel turn for tens of seconds without water, take out the makeup Remove the screw plug of the guide wheel seat and inject the grease to discharge the dirt through the oil gap so that the guide wheel and the bearing are always in a relatively clean state.
The wire cutter shaft and the coupling and key on the motor should be in a tight and stable state. Once the looseness of the key and the impact of the coupling occur, replace the coupling cushion immediately. And keys. After a long period of commutation with a gap, the keyway on the shaft is deformed and enlarged.
The cable between the wire-cutting machine control cabinet and the machine tool must be protected by a cover or plastic plate. The cable should be freely stepped on. The cable should be in a slack free state. Do not pull it outside. Do not force the cable plug. The cable corrugated sheath is cracked and flattened.
The wire cutting machine console (cabinet) should be handled with care, and the oily hands should not be plugged or unplugged or touched.
No part of the surface of the wire cutting machine should be knocked or bumped. In particular, the wire frame and the bed surface should not be interfered by the overtravel motion, which will seriously damage the machine parts or precision.
Always pay attention to make the conductive block in good electrical conductivity and insulation between the bed and the bed. The pad on the workbench must be insulated from the bed. The stepper motor must be in a free line. The stepper motor ensures that there is no dirty water. .
Cars require regular maintenance and maintenance, and the machine is the same. As long as the operator treats it with sincerity, it will also be rewarded with real benefits.
Copper Tube,Outdoor Copper Pipe Insulation,Ac Insulated Copper Pipe,Outside Copper Pipe Insulation
LONG TERM ELEC. CO., LTD , https://www.longterm-hvac.com