INA actively adjusts imported bearings

Source: China Bearing Network Time: 2013-02-16

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

INA actively adjusts the imported bearings when the bearing's aspect ratio is greater than 1.5; or the shaft's steel is weak; or because the two bearings are not mounted on the same steel frame; the degree of installation is difficult to ensure; Part of the touch; therefore part of the wear is severe; in order to deal with the above problems; the best choice is INA imported active positioning bearing. The layout of this bearing is the bearing seat is the spherical touch; the lower bearing is convex spherical; the bearing is concave Spherical surface; easy to adjust the core. To avoid excessive rotation of the bearing bush, slide out from the bearing seat; put a cylindrical pin in the center of the spherical surface of the bearing bearing housing and the bearing bush; the lower half of the pin is firmly fixed on the bearing seat; The half part is pierced into the oval nail hole of the bearing bush.

Recommend to friends comments close window

Bearing related knowledge

Skill analysis: the use of bearings focuses on the analysis of several commonly used imported bearings, radiators, sliding bearing damage type, thrust bearing device, detection bearing device common sense

This article links to http://
Please indicate the bearing network http://

Previous: "TIMKEN Bearing Protection and Protection" Detailed Explanation: The introduction of solid smooth bearings and the applicable occasions

FIBERGLASS FABRIC

Jinwu Glass Fiber Co., Ltd , https://www.jwglassfiber.com