The loader scale pays attention to five aspects in operation and use, which can prolong the service life and make the weighing result more accurate. Shanghai Shengliang Electronic Technology Co., Ltd. recommends that users pay attention to the following five points when using the loader scale for weighing measurement. Choose to brighten and choose to trust.
1. The Jm-t7000 loader scale should start the loader before starting the machine and lift the boom 5-10 times for preheating. The purpose is to preheat the hydraulic oil and pressure sensor to the normal working temperature and reduce the oil temperature. The effect of unstable symmetry and precision.
Second, in the weighing process of the loader scale, the loader should be avoided, and the speed can be arbitrarily determined after the weighing is over. If driving in weighing, the speed should be controlled below 5km/h, but the accuracy will be reduced by 0.5%.
3. During the weighing process of the loader scale, when lifting the boom through the position sensor, the lifting speed should be as uniform as possible (to minimize the increase/decrease or throttle stop).
Fourth, the user loader should try to increase the weighing on the level of the ground or the slope is less than 15 degrees.
5. When the single weighing is completed, the loader hopper should be lowered to the lowest position for the next time to use the JM-T7000 loader scale for weighing the shovel.
Copper nuts made of all kinds of embossed wire (usually lead brass, such as H59, 3604, 3602). Our daily contact with the embedded knurled copper nuts are processed by precision automatic lathes. The reference standard of embedded knurled copper nut comes from GB/T809, but the technical parameters of all kinds of embedded nuts produced by our company exceed the relevant indexes required by the national standard.
Knurling copper nut is mainly used for hardware Spring, shaped spring, craft gift spring, battery spring, spring antenna,key ring, phosphorus copper spring CNC automatic lathe turning parts (copper car parts, iron, aluminum car parts), metal stamping parts, electronic parts, iron shaft, single Rachel,Rachel, iron pin, non-standard Screw nut,fittings,fasteners, wire forming (wire card holder, Model aircraft landing gear, S hook, R latch, triangle buckle, D buckle) and other hardware products, belonging to the copper nut series.
Brass Nut,insert nut,knurled nut,injection nut,hex nut
Shenzhen Lanejoy Technology Co.,LTD , https://www.szcoolingrack.com