Various faucet installation and acceptance common faucet parts

â—Ž Single-hole basin faucet installation

Buy single-handle basin faucet should pay attention to the outlet diameter, most of the market is now hard pipe water, so you should pay attention to set aside the height of the mouth, from the basin down 35 points the most appropriate. When installing, it must be equipped with a special angle valve, and the angle valve must be fixed with the hot and cold water pipes of the wall outlet. When you find a distance between the angle valve and the faucet hose, buy a special extension tube to connect. Remember, don't use other pipes to connect, because if the water pressure is high, it can easily fall off and leak, causing damage to you. If the inlet pipe is longer than the outlet pipe, you can cut off the part according to your needs. If the angle is not appropriate, you can bend it to your desired position. Remember: Do not bend hard to 90 degrees or more than 90 degrees. When installing the basin to remove water, do not forget to purchase the faucet's small connector (short for the faucet). Don't forget to flush the water pipe buried in the wall before you install it.

â—ŽInstallation of shower and bathtub mixer (wall)

When you have purchased showers, bathtubs, wall taps, you can choose the appropriate height to bury the water pipe. Hot and cold water pipes must be spaced 15 cm apart. Before installation, you must not forget to flush the water pipe to avoid excessive water quality and damage the mixer.

Concealed shower, bath faucet: After purchasing a concealed faucet, it is generally necessary to embed the valve plug of the faucet in the wall. Before embedding, you must pay attention to the thickness of the bathroom wall. If the wall is too thin, the valve plug cannot be embedded. The plastic protection cover of the valve plug should not be easily removed when it is embedded, so as to prevent the cement and other chores from damaging the valve plug when it is embedded. In addition, when embedding the valve core, it should also pay attention to the direction of the valve core up and down, left and right, so as not to miss the valve core. Wall mounted faucets are pre-installed into the water pipe with dimensional deviations that can be adjusted using the available adjustments.

â—Ž Installation of thermostatic faucet

Before installing the thermostat, please check whether the water pipe is hot or cold. Remember not to connect the hot and cold water pipes incorrectly to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostats because the water pressure is too low. Do not forget to install the hot and cold water filter when installing the thermostat.

â—Ž Single hole kitchen faucet installation

The requirement is stable, because the kitchen mixer is used frequently, and it is easy to loosen and move it. Therefore, the lock nut must be tightened. At present, there are some faucets on the market that use nuts to fasten the nuts. This kind of stability is very good. If it can solve the problem of water-removal, it will be a popular trend in the future.